Block Diagrams; Troubleshooting Information - PRESONUS StudioLive III Series Owner's Manual

14 Technical Information
14.3

Block Diagrams

14.3 Block Diagrams
14.4

Troubleshooting Information

The block diagrams for our StudioLive Series III mixers are too large to be included in
this manual. Please visit our website for the latest Series III block diagrams in Adobe
PDF format.
Please check the PreSonus Web site (www.presonus.com) regularly for software
information and updates, firmware updates, and support documentation, including
frequently asked questions.
Online technical support is available to registered users through your My PreSonus
account. Visit my.presonus.com
Fader Movements Have No Effect on Audio. Press the Main Mix button in the
Mix Select section, then try moving channel faders up and down, to see if their
movement affects the overall output volume, as shown by the main output meter. If
not, make sure that your channels are assigned to the Main bus.
No Internal Effects in the Main Bus. Press the Aux button in the Metering section
and verify the output levels of the internal FX buses. If the level is too low, use the
effect return channel to increase the master level for the effects mix. Press the Select
button for each FX bus and make sure it is assigned to the main output in the Assign
section of the Fat Channel.
No Output on the Solo Bus While Monitoring. Verify that both the Solo volume
and the headphone, or monitor, volume is at a reasonable level for comfortable
listening. Make sure that you only have Solo selected in the Monitor section of your
StudioLive.
Can't Hear Main Mix in Headphones. Verify that the Main mix is enabled as
the source for the headphones and that the headphone output control is at a
sufficient level.
Monitor Bus Controls Not Changing Routing. Verify that your monitors are
connected to the Control Room outputs on the rear panel of your StudioLive, not the
Main outputs.
Main Fader Doesn't Control Mix Level. Verify that your monitors are connected to
the Main outputs on the rear panel of your StudioLive, not the Control Room outputs.
to register.
StudioLive™ Series III
Owner's Manual
150