Table of Contents
Advertisement
Select Speedometer Source
The default SPEEDOMETER source is set to GPS. To change the speed-
ometer source enter the DATA SRCS menu, then:
1.) Use the UP or DOWN buttons to select SPEEDO.
2.) Press and hold the MODE button to enter the selection.
3.) Use the UP or DOWN buttons to select PADL WHEEL, GPS or BUS
DATA.
IMPORTANT:
Set the SPEEDO source to PADL WHEEL when an ana-
log paddle wheel transducer is used as the speed input source.
Set the SPEEDO source to GPS when GPS data is used as the speed
input source.
Set the SPEEDO source to BUS DATA when an NMEA 2000 paddle wheel
transducer is used as the speed input source.
4.) Press and hold the MODE button to enter the selection.
124
010153
010154
Advertisement
Table of Contents
