Table of Contents
Advertisement
Trim
The ICON tachometer can monitor multiple trim senders. By default the trim
sender is set to NMEA 2000. To change the trim sender setting, enter the
DATA SOURCES menu then:
1.) Use the UP or DOWN buttons to select TRIM.
2.) Press and hold the MODE button to enter the selection.
3.) Use the UP or DOWN buttons to select SELECT SENDER.
4.) Press and hold the MODE button to enter the selection.
5.) Use the UP or DOWN buttons to select the desired trim sender.
6.) Press and hold the MODE buttons to save the selection.
Calibrate Trim Sender:
1.) Use the UP or DOWN buttons to select TRIM.
2.) Press and hold the MODE button to enter the selection.
3.) Use the UP or DOWN buttons to select CAL SENDER.
4.) Press and hold the MODE button to enter calibration.
5.) The LCD screen displays: HOLD MODE FOR > 1 SEC WHEN TRIM
FULL DOWN,
6.) Make sure the engine is in the full trim DOWN position. Then press and
hold the MODE button to save the trim DOWN position.
7.) The LCD screen displays: SETTING SAVED!
102
010125
010126
Advertisement
Table of Contents
