Mute Microphone; Tone Dialing Switch-Over - Uniden DCT 7488 SERIES Owner's Manual

Mute Microphone

Tone Dialing Switch-over

note
•The tone feature only
applies when the dial
mode is set to pulse.
•This special number
can be stored in a
memory location. This
is referred to as Chain
Dialing (see page 41).
[ 3 7 ] B A S I C S
You can temporarily mute the microphone so that the caller cannot hear you.
1) Press menu/clear (or the MENU soft key on the base) during talk mode (while
the phone is in use).
2) Press /volume up/down to move the pointer to
tone (or the OK soft key on the base).
To cancel muting, repeat above step again when Mute is set to on,
appears.
If your telephone company requires pulse dialing, you can
switchover to tone dialing after the call connects. This
feature is useful when you need tone dialing to use any
automated menu systems, such as telephone bank tellers,
telephone prescription refills, customer support menus,
etc.
If your phone is set to pulse dialing mode, make your call
normally. Once your call connects, press the
key. Any digits you enter from then on will be sent as
tone digits. When this particular call ends, the phone
automatically returns to pulse dialing mode.
and then select/
Mute
appears in the display.
Mu te On
/tone/
*
w w w . u n i d e n . c o m
/audio
Mute Of f