Uniden DCT 7488 SERIES Owner's Manual page 59

played. Each time you press the CHANGE soft key, the phone switches the
outgoing message between the prerecorded and the personal outgoing message.
To delete the personal greeting, press the DELETE soft key.
Setting a Security Code
You need to select a two-digit security code in order to play your messages from a
remote location. When you try to access your messages from another phone, you
must enter your security code.
1) Press menu/clear (or the MENU soft key on the base).
Select the Answ. Setup menu, and then the Security
Code submenu.
2) Enter a two-digit security code (01-99) using the
number keypad (0-9).
3) Press select/ /audio tone (or the OK soft key on the base). You will hear a
confirmation tone.
Setting the Ring Time
Ring Time allows you to set the number of rings the caller hears before your answering
system plays the outgoing message. You can set the ring time to answer after two, four,
or six rings. If you enable the Toll Saver (TS), the answering system picks up after two
rings if you have new messages, and after four rings if there are none.
1) Press menu/clear (or the MENU soft key). Select the
Answ. Setup menu, and then the Ring Time submenu.
w w w . u n i d e n . c o m
T H E I N T E G R A T E D A N S W E R I N G D E V I C E [ 5 8 ]
note
Through this chapter,
we use Handset LCD
image to describe steps.