Table of Contents
Advertisement
UP349BH (WDECT2300) ENG OM
• The tone feature only
applies when the dial
mode is set to pulse.
• This special number
can be stored in a
memory location.
This is referred to as
Chain Dialing (see
page 31)
[ 20 ]
5/12/04
10:53 AM
Page 20
MUTE MICROPHONE
You can temporarily turn off the microphone so that the person you are talking with
cannot hear you.
1) Press
/del during talk mode (while phone is in use).
2) Press
/vol/
or
/vol/
and
appear in the display. To cancel muting, repeat above step again
when Mute is set to on,
TONE DIALING SWITCH-OVER (AUSTRALIA ONLY)
Some telephone companies use equipment that requires pulse
dialing (sometimes referred to as rotary dialing). If you need
to enter tone dialing digits, you can switch-over to tone
dialing during the call. This feature is useful when you need
tone dialing to use automated systems, for example, entering
your bank account number after you have called your bank.
Initially make your call with the pulse dialing mode. Once your
call connects, press
. Enter the desired number.
These digits will be sent as tone dialing. Once the call ends,
the tone mode is canceled and pulse dialing mode resumes.
TRAVELING OUT-OF-RANGE
During a call, as you begin to move your handset too far from your base unit, noise
may increase. If you pass the range limits of the base unit, you will hear a beep and
see
on the display, and then the handset returns to standby mode.
You may return to the call if you move your handset within the range limits of the
base and press
or
to move the pointer to
and then
appears.
speaker within 30 seconds.
.
Advertisement
Table of Contents
