Setting the Dial Mode
Dial Mode sets the dial mode to tone or pulse. Most phone systems use tone dialing;
the default setting is tone dialing. Set the dialing mode to match the dialing
system used by your local phone service.
• If you are not sure of your dialing system, make a trial call. If the call connects, leave the
setting as is; otherwise set the unit to pulse dialing.
• If your phone system requires pulse dialing and you need to send DTMF tones in certain
situations during a call, you may switch over to tone dialing (refer to "Tone Dialing
Switch-over" on page 37).
1)Press menu/clear (or the MENU soft key on the
base). Select the Global Setup menu, and then the
Dial Mode submenu.
2) Press
/volume up/down to select
(the initial setting is Tone).
3) Press select/
/audio tone (or the OK soft key on the base). You will hear a
confirmation tone.
w w w . u n i d e n . c o m
or
To ne
Pu lse
G E T T I N G S T A R T E D [ 2 8 ]