Invacare Pronto M41 Series User Manual page 50

Invacare® Pronto™ M41 Series with SureStep®
Upper multi-angle
A
rotational pivot
Upper linkage
B
Middle linkage
C
D Lower linkage
Mounting post
E
Lower multi-angle
F
rotational pivot
Installing
• 2.5 mm Allen key
• 4 mm Allen key
• 5 mm Allen key
50
• 360° rotation
• 80° tilt
• 180° rotation
• 100° rotation
• 180° rotation
• 360° rotation in
90° increments
• 360° rotation
• 50° tilt
1. Using hardware provided, align and install headrest
clamp assembly into existing mounting holes in backrest
pan A.
2. Install headrest pad (not shown) to headrest rod using
mounting hardware provided.
The headrest pad can be adjusted to any desired
angle via the pivot ball at the end of the
headrest rod by loosening and tightening the
mounting hardware.
3. Loosen and remove lower D-Ring E from hardware.
4. Slide vertical mounting post B into clamp assembly
and adjust overall height of headrest pad to desired
position. Tighten knob D.
For proper set-up headrest should be adjusted to user's
ear height.
5. Adjust upper D-Ring C as required.
6. Once final height position is set, adjust lower D-Ring E
so that it rests flush with bottom of clamp assembly
(to prevent slipping).
1553378-G