Table of Contents
Advertisement
Procedure
10
11
12
13
1
Preparing the Machine
No Parts Required
Procedure
1.
Park the machine on a level surface.
2.
Lower the attachments.
3.
Engage the parking brake.
4.
Shut off the engine and remove the key.
5.
Thoroughly clean the machine. Remove all
debris to ensure that the mounting brackets will
fit properly and that no dirt or debris gets into
the hydraulic system.
2
Removing the Air Cleaner
No Parts Required
Procedure
1.
Thoroughly clean the area around the air
cleaner.
2.
Loosen the radiator clamp around the hose and
lower the clamp onto the hose.
Description
Large hydraulic hose
Hydraulic hose with fittings
Large hose clamp
Small hose clamp
Small molded hydraulic hose
R-clamp
Bolt (5/16 x 7/8 inch)
Flange nut (5/16 inch)
No parts required
Harness
Switch
Fuse
Dipstick
Hydraulic fluid
Qty.
1
1
2
2
Install the hydraulic hoses.
1
1
1
1
–
Tighten all connections.
1
1
Install the switch and harness.
1
1
Install the hydraulic fluid and check for
25.5 L
leaks.
(6-3/4 US
gallons)
3.
Remove the inside bolt holding the air cleaner
in place.
4.
Remove the air-cleaner cover and filter
2).
1. Air-cleaner canister
2. Air filter
5.
Remove the hose from the air-cleaner canister.
6.
Spread the air-cleaner strap open and pull it
over the end of the canister where the filter was
taken out
(Figure
4
Use
Figure 2
3. Canister cover
3).
(Figure
g003574
Advertisement
Table of Contents
