Table of Contents
Advertisement
3.
Insert the new dipstick and check the level of
the hydraulic fluid
4.
Slowly add the additional fluid to bring it to the
Full mark.
Figure 37
1. Hydraulic-tank cap
2. Dipstick
5.
Start the machine and let it run for 5 minutes.
6.
Check for any leaks in the system with a piece
of cardboard.
WARNING
Hydraulic fluid escaping under pressure
can penetrate skin and cause injury.
If hydraulic fluid is injected into the skin
it must be surgically removed within a
few hours by a doctor familiar with this
type of injury. Gangrene may result if
this is not done.
• Keep body and hands away from
pin-hole leaks or nozzles that eject
high-pressure hydraulic fluid.
• Use cardboard or paper to find
hydraulic leaks.
• Safely relieve all pressure in the
hydraulic system before performing
any work on the hydraulic system.
• Make sure that all hydraulic-fluid
hoses and lines are in good condition
and that all hydraulic connections
and fittings are tight before applying
pressure to the hydraulic system.
7.
Install the left front screen to the frame.
(Figure
37).
3. Hydraulic tank
8.
Install the front shroud to the frame with 4
flange-head screws.
9.
Install the 4 flange-head screws securing the left
wheel shroud to the frame
10.
Install the left rear tire
g003618
1. Left wheel shroud
2. Flange-head screws
11.
Lower the machine onto the ground.
12.
Install the rear hitch shield.
13.
Install the air-cleaner assembly.
17
(Figure
38).
(Figure
38).
Figure 38
3. Left tire
4. Nut
g003581
Advertisement
Table of Contents
