Table of Contents
Advertisement
1. Hydraulic tank
2. Coupler bracket
3. Large 90-degree elbow
installed in tank
10
Installing the Hydraulic
Hoses
Parts needed for this procedure:
1
Large hydraulic hose
1
Hydraulic hose with fittings
2
Large hose clamp
2
Small hose clamp
1
Small molded hydraulic hose
1
R-clamp
1
Bolt (5/16 x 7/8 inch)
1
Flange nut (5/16 inch)
Procedure
Note:
Make sure that nothing rubs against any hoses.
1.
Slide the 2 large hose clamps onto the large
hydraulic hose.
2.
Install the large hydraulic hose to the 90-degree
elbow installed to the side of the hydraulic pump
(Figure 27
and
Figure
Figure 26
4. Hydraulic line number 3
5. Machine frame
31).
3.
Tighten a hose clamp around the hose and
elbow
(Figure
4.
Install the large hydraulic hose to hydraulic line
number 3
5.
Tighten the hose clamp around the hose and
hydraulic line number 3
g003582
1. Hydraulic line number 3
2. Hose clamp
3. Large hydraulic hose
6.
Install an R-clamp onto the large hydraulic hose
as shown in
1. Nut (3/8 inch)
2. R-clamp
7.
Install the R-clamp to the retainer bracket with a
bolt (5/16 x 7/8 inch) and a nut (5/16 inch); refer
to
Figure
13
27).
(Figure
27).
(Figure
Figure 27
4. Hydraulic pump
5. 90-degree elbow
6. Hose clamp
Figure
28.
Figure 28
3. Bolt (3/8 x 3/4 inch)
4. Retainer bracket
28.
27).
g003614
g003615
Advertisement
Table of Contents
