Table of Contents
Advertisement
Figure 34
1. Main harness connector
6.
Install the main harness connector to the main
harness
(Figure
35).
7.
Install the control panel to the machine.
Figure 35
1. Switch
2. Screw
3. Control panel
Install the fuse into right slot in the fuse block
(Figure
33).
8.
Install the square connector to the relay installed
next with the valve
9.
Install the small connector to the valve
36).
2. Jumper wire
4. Switch connector
5. Main harness connector
(Figure
36).
(Figure
10.
Fasten the wire harness to the valve with a
cable tie.
g005083
1. Valve
2. Small connector
3. Diode
13
Installing the Hydraulic
Fluid and Checking for
Leaks
Parts needed for this procedure:
1
Dipstick
25.5 L
(6-3/4
Hydraulic fluid
US
g003648
gallons)
Procedure
The hydraulic system capacity is now 25.5 L (6-3/4
US gallons).
Refer to the Operator's Manual for the correct fluid
to use.
1.
Remove the old dipstick from the hydraulic tank
and discard.
2.
Slowly pour approximately 80% of the specified
fluid into the tank.
16
Figure 36
4. Cable tie
5. Relay
6. Square connector
g003620
Advertisement
Table of Contents
