Table of Contents
Advertisement
Chapter 7
ibconf—Interface Bus Configuration Utility
Output Selection Level
Figure 7-4 shows the output selection level of ibconf.
Figure 7-4. Output Selection Level of ibconf
In the output selection level, you can select the configuration files that should be
updated by ibconf. To create or update a data file, respond yes to copy
changes to the data file. The data file confil.cf (the default name) is then
created or opened and the new configuration is stored into it.
If you select yes to copy changes to the memory resident driver, ibconf
updates the driver that is currently resident in memory. If you select yes to
copy changes to drivers on disk, ibconf updates the driver file on disk.
Board and Device Configuration Options
To view detailed information about each characteristic, position the cursor in the
field for that characteristic. For information on characteristics specific to a given
driver, check the getting-started manual that came with your interface board.
The following paragraphs describe the options available in ibconf for the NI-
488.2M software for OS/2.
© National Instruments Corp.
7-9
NI-488.2M SRM for OS/2
Advertisement
Table of Contents
