(Dis)Connect; Edit; Exit - National Instruments NI-488.2M Software Reference Manual

ibconf—Interface Bus Configuration Utility Chapter 7

(Dis)connect

Use <F5> to connect or disconnect a device to or from a particular access board.
Move the cursor to the device that is to be connected or disconnected by using
the cursor control keys and then pressing <F5>.

Edit

Use <F8> to edit or examine the characteristics of a particular board or device.
Move to the board or device that you want to edit by using the cursor control
keys and pressing <F8>. This places you in the description level of ibconf and
lists all the characteristics for the particular board or device that you want to edit.
To exit edit, use <F9> or <Esc>.

Exit

Use <F9> or <Esc> to exit ibconf. If you have made changes and have
pressed <F9> to exit, ibconf displays Save configuration?. Type y
(yes) to save the changes or n (no) to discard the changes. For more
information, refer to the Exiting ibconf section, which is located later in this
chapter.
If you have pressed <F9> and have then decided not to exit, press <F9> again to
abort the function.
NI-488.2M SRM for OS/2 7-6 © National Instruments Corp.