JRC NCR-333 Instruction Manual page 99

(B) When not connected to the BAM
With referring 6.3.5.2(B), confirm that failure alarm is not occurring. If any alarm occurs, check the
cause of the alarm. NCR-333 Alarm Table is followings.
NCR-333 Alarm Table
Failure alarm list (ALR sentence output)
Alarm Indication
Alarm Occurrence Conditions
No.
005 Built in self test failure
After carrying out self-diagnosis, NCR-333 detected
006 General failure
that the input voltage was abnormal.
005 Built in self test failure
After carrying out self-diagnosis, NCR-333 detected
051 Antenna malfunction
that the output voltage of antenna terminal was low
voltage.
004 Receiver malfunction
After carrying out self-diagnosis, NCR-333 detected
005 Built in self test failure
that the receiver 1 (518kHz) could not receive
056 Receiver 1 malfunction
because of abnormalities.
004 Receiver malfunction
After carrying out self-diagnosis, NCR-333 detected
005 Built in self test failure
that the receiver 2 (490kHz) could not receive
057 Receiver 2 malfunction
because of abnormalities.
004 Receiver malfunction After carrying out self-diagnosis, NCR-333 detected
005 Built in self test failure
that the receiver 3 (4209.5kHz) could not receive
058 Receiver 3 malfunction
because of abnormalities.
006
General failure The input voltage is low level.
053
Rx
unit modem error
The receiver 1 (518kHz) could not receive because
056 Receiver 1 malfunction
of internal MODEM failure.
053
Rx
unit modem error
The receiver 2 (490kHz) could not receive because
057 Receiver 2 malfunction
of internal MODEM failure.
053
Rx
unit modem error The receiver 3 (4209.5kHz) could not receive
058 Receiver 3 malfunction
because of internal MODEM failure.
051 Antenna malfunction The output voltage of antenna terminal is low
voltage.
052 Flash memory error
The flash memory data is abnormal.
054 Printer error
External printer is abnormal.
055 EXT SIO output error
•DISP~ output port is abnormal.
7-3