JRC NCR-333 Instruction Manual page 42

Navtex receiver
Hide thumbs Also See for NCR-333:
Table of Contents

Advertisement

The message type and the message identification codes are as follows.
The message identification codes displayed on upper-left side of the message text screen (niA01. in the
above example) indicates the message type.
These codes consist of four alpha-numeric characters which denote the coast station originating the
message, the message type and the report number.
a. First character
The coast station that has transmitted the message is assigned by a character from A to Z.
b. Second character
This character identifies the type of message.
[A]
Navigational warnings
[B]
Meteorological warnings
[C]
Ice reports
[D]
Search and rescue information, and pirate attack warnings
[E]
Meteorological forecasts
[F]
Pilot service messages
[G]
AIS
[H]
LORAN-e messages
[J]
SATNAV messages
[K]
Other electronic navaid messages
[L]
Navigational warnings (Additional to letter
MA")
[V - Y]
Special services
[Z]
QRU (No messages on hand)
c. Third and fourth characters
These characters denote the report number assigned to the message by the coast station where the
message originated.
The four-character identification code is stored in memory only when the message is received at a
character error rate (CER) of 33% or less. When an incoming message has the same identification code
as one already stored message at CER of 4% or less in memory (about 70
hours),
it will not be displayed
and stored. The above, however, does not apply to report number '00'. For report number '00', the
code Is not held In memory and messages are displayed and stored each time they are received
when the stations are selected.
[Notes
1
After receiving the search and rescue [D] message will display the detailed screen of search and
rescue information message until the alarm buzzer is stopped.
Press the CLR key to display the newest message after stopping the alarm buzzer.
I
a. Clear the unread mark
The message text is displayed after the message has been received.
Unread mark on the status bar shows unread messages has been received.
Procedures
1) If the lEN] key is pressed, the caution sentence
disappears, and this message changes to read
message. If all messages are read messages, the
MB"
mark of status bar is cleared_
[Notes
1
6-8
- Unread messages can also be checked on the
message list 1 or 2.
(Refer to
"6.2.7.2"
or M6.2.7.3")
Be sure to clear the unread mark after reading a
message.
KEIHIN KO.
TOKYO EAST PASSAGE.
DAYTIME DAILY UNTIL 08 JULY 2006
AREA BOUDED BY
35-35-37.9N 139-47-18.4E
35-34-58.9N 139-48-08.6E
35-34-53.9N 139-48-03. 1E
35-35-02.0N 139-47-55.3E
35-35-32.3N 139-47-16.6E
35-35-35.0N 139-47-15. lE
35-33-37.9N 139-46-18.4E
35-33-58.9N 139-46-16.6E
I
unread mark
I

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents