Spacer Table Attachment/Removal; Attaching The Spacer Table - Roland VersaUV LEF2-300 Regular Maintenance Manual

Spacer Table Attachment/Removal

Attach or remove the spacer table according to the thickness of the object to be printed on.
• Thickness of object to be printed on is 0 to 100 mm (0 to 3.94 in.): Attach
• Thickness of object to be printed on is 100 to 200 mm (3.94 to 7.87 in.): Remove
The spacer table does not have a suction function. When using the spacer table, turn off the vacuum function in the
printer settings.

Attaching the Spacer Table

CAUTION
Procedure
A
Turning on the sub power
B
Press [SETUP].
[SETUP] starts to flash.
C
Press [DOWN] or [▼] to move the flat table to the lowest and frontmost (forward) position.
D
Open the front cover.
E
Remove any installed positioning jigs.
F
Temporarily tighten the screws in the 4 locations shown in the figure.
Make a space between the screw heads and the table of approximately 2 mm (78.7 mil) (
4
Sharp components
Take care to prevent injury from touching the sharp edges of the spacer table.
1.Introduction
1
).