Roland VersaUV LEF2-300 Regular Maintenance Manual page 16

Maintenance That Must Be Performed Daily
C
Press [ENTER].
The print heads return to the home position and the following screen is displayed.
WIDTH: XXX.Xmm
LENGTH:XXX.Xmm
MEMO
• The previously set values are displayed for "WIDTH" and "LENGTH."
• When the object to be printed on comes into contact with the head gap sensor, the screen shown below
appears and the setup is canceled. Redo from
automatically."
CHECK TABLE
D
Press [ ], [ ], [ ], or [ ] to set the "WIDTH" to 110 mm (4.3 in.) or more and the "LENGTH"
to 70 mm (2.8 in.) or more.
The pointer moves until it points to a position in the inner left of the print area.
E
Close the front cover when it is open.
F
Press [ENTER].
The print area is specified. Print heads return to the standby position.
G
Make sure the "W" (width), "L" (length), and "H" (height) values on the menu screen are as
intended.
W:110mm L: 70mm
H:100.0mm
14
.
HEIGHT
2.Regular Maintenance
P. 12 "4. The height of the object to be printed on is detected