Setting Up The Machine; Attaching The Spacer Table - Roland VersaUV LEF2-300 Setup Manual

Setting Up the Machine

Attaching the Spacer Table

Attach the spacer table after completing the "Ink Filling"procedure.
CAUTION
Procedure
A
Turning on the sub power
B
Press [SETUP].
[SETUP] starts to flash.
C
Press [DOWN] or [▼] to move the flat table to the lowest and frontmost (forward) position.
D
Open the front cover.
E
Remove any installed positioning jigs.
F
Temporarily tighten the screws in the 4 locations shown in the figure.
Make a space between the screw heads and the table of approximately 2 mm (78.7 mil) (
G
Check the front and rear positions of the spacer table.
The side with a notch at the fixing location is the rear side, and the side without a notch is the front side.
Sharp components
Take care to prevent injury from touching the sharp edges of the spacer table.
1
).
7