Roland VersaUV LEF2-300 Regular Maintenance Manual page 14

Maintenance That Must Be Performed Daily
D
Secure the paper for the printing test.
Printing tests are used to check that no dot drop-out occurs. Use paper for testing (width 110 mm
(4.33 in.) × length 70 mm (2.76 in.) or more), not the object that will actually be printed on.
MEMO
There are two types of printing tests. Select the type of printing test to match the paper to be used.
Type
CLEANING
TEST PRINT
CLEANING
TEST PRINT2
MEMO
The suction function cannot be used to secure the media in place. Secure the media with tape.
Secure the media in place using a substance such as commercially available tape affixed directly to the flat table.
It can be set anywhere as long as it does not protrude from the top of the flat table. Be aware that folds or kinks in
the paper might hit the interior of the printer and cause damage.
E
Close the front cover.
4.
The height of the object to be printed on is detected automatically.
Procedure
A
Press [SETUP].
[SETUP] starts to flash.
B
Open the front cover.
C
Press [ ], [ ], [UP], or [DOWN] to move the flat table, bringing the highest position of the
print surface into contact with the head gap sensor.
When the head gap sensor reacts, a buzzer goes off.
To fine-tune the height, open the front cover and make the adjustments from a close distance.
12
It is difficult to check the white ink if the paper for use in the printing test is
white. We recommend printing on transparent paper.
Because white ink is printed on a black undercoat, white ink can be easily
checked even when printed on white paper. However, printing takes longer
than "TEST PRINT."
2.Regular Maintenance
Features