Roland VersaUV LEF2-300 Regular Maintenance Manual page 15

D
Press [ ] to display the screen shown below.
AUTO DETECTION
E
Close the front cover.
IMPORTANT
The following step moves the flat table rearward. If the object to be printed on hits the head gap sensor
forcefully, the object to be printed on may be damaged or the head gap sensor may malfunction.
To re-adjust the height of the object to be printed on, press [ ] and redo the procedure from step
F
Press [ENTER].
The flat table moves and the height of the object to be printed on is detected. The flat table rises while
moving backward and forward until the object to be printed on reaches a position where it comes in
contact with the head gap sensor.
When the flat table stops moving and one short beep is heard, the setup is complete.
The height of the object to be printed on will be set automatically to a position about 1 mm (39.4 mil)
away from the print head's ink emission surface.
5.
Set the print area.
Procedure
A
Press [ ], [ ], [ ], or [ ] when the following screen appears.
SCAN: 0.0mm
FEED: 0.0mm
The flat table and the print heads move so that the pointer points at the previously set printing base
position.
B
Press [ ], [ ], [ ], or [ ] to move the pointer until it points to a position in the right
foreground of the print area (the base position).
Maintenance That Must Be Performed Daily
2.Regular Maintenance
B
.
13