Section 4: Operations; Operation Overview - Grizzly G0812 Owner's Manual

SECTION 4: OPERATIONS

Operation Overview

The purpose of this overview is to provide the nov-
ice machine operator with a basic understanding
of how the machine is used during operation, so
the machine controls/components discussed later
in this manual are easier to understand.
Due to the generic nature of this overview, it is
not intended to be an instructional guide. To learn
more about specific operations, read this entire
manual, seek additional training from experienced
machine operators, and do additional research
outside of this manual by reading "how-to" books,
trade magazines, or websites.
To reduce your risk of
serious injury, read this
entire
using machine.
To reduce risk of eye injury from flying
chips or lung damage from breathing dust,
always wear safety glasses and a respirator
when operating this machine.
If you are not experienced with this type
of machine, WE STRONGLY RECOMMEND
that you seek additional training outside of
this manual. Read books/magazines or get
formal training before beginning any proj-
ects. Regardless of the content in this sec-
tion, Grizzly Industrial will not be held liable
for accidents caused by lack of training.
Model G0812 (Mfd. Since 2/16)
manual BEFORE
To complete a typical cutting operation, the
operator does the following:
1. Examines workpiece to make sure it is suit-
able for cutting.
2. Adjusts headstock angle and vise position,
then securely clamps workpiece in vise using
manual and hydraulic controls.
3. Sets up splash guard and work stop if need-
ed for operation.
4. Adjusts blade guide arm as close to workpiece
as possible, and verifies blade is properly
tensioned.
5. Makes sure workpiece and machine are
stable and that there are no obstructions in
the way of cut.
6. Sets blade speed.
7. Ensures machine has adequate amount of
coolant.
8.
Puts on safety glasses and respirator.
9.
Raises headstock using hydraulic controls.
10. Starts machine and waits for blade to reach
full speed, then turns on coolant pump.
11. Turns feed rate dial clockwise, lowers blade
into workpiece, and allows machine to com-
plete cut.
12. Once machine has stopped, removes
workpiece.
13. When finished, turns machine OFF.
-23-