Grizzly G0812 Owner's Manual page 7

Headstock
M
P
Figure 3. Headstock controls and components.
Q
Figure 4. Additional headstock controls.
M. Blade Guide Arm: Holds blade guide that
supports bandsaw blade. Arm is placed as
close to workpiece as possible during cutting
to prevent blade from twisting.
N. Blade Guide Scale: Displays position of
blade guide arm relative to workpiece.
O. Blade Speed Adjustment Knob: Controls
bandsaw blade speed. Rotate knob clockwise
to decrease blade speed or counterclockwise
to increase blade speed. IMPORTANT: To
avoid damaging machine, ONLY change
blade speeds while the motor is running.
P. Work Stop: Can be positioned on either
side of vise base to support repetitive cutting
operations. The stop is placed on same side
of machine where cut is made.
Q. Auto-Stop Adjustment Lever: Sets maxi-
mum headstock height. Adjust by changing
position of lower limit switch. This feature
is useful for speeding up repetitive cuts by
eliminating unnecessary headstock travel.
R. Blade Tension Handwheel: Increases or
decreases blade tension.
Model G0812 (Mfd. Since 2/16)
O
N
R
Vise Table
Figure 5. Vise table controls.
S. Movable Vise Jaw: Features quick release
that allows jaw width to be adjusted when
changing from one workpiece size to another.
T. Vise Handwheel: Rotate to manually position
movable vise jaw close to workpiece.
U. Vise Locks: Loosen to move vise base or
tighten to secure its position.
S
T
U
-5-