Grizzly G0812 Owner's Manual page 61

5. Connect machine to power and lower head-
stock all the way until it stops moving.
6. DISCONNECT MACHINE FROM POWER
and place a 90° square flat on table and
against both fixed vise jaw and blade, as
shown in Figure 92. The square should fit
snugly against fixed jaw and blade.
Fixed Vise Jaw
Square
Figure 92. Testing vise/blade squareness.
— If square fits snugly against fixed jaw and
blade, no further steps are necessary.
— If square does not fit snugly against sta-
tionary jaw and blade, rotate flip-stop out
to disengage it, and loosen jam nut shown
in Figure 93. Thread stop bolt inward or
outward as necessary, then re-engage
flip-stop.
Stop Block
Jam Nut
Figure 93. Flip-stop bolt and jam nut location.
7.
Rotate headstock until turret stops against
flip-stop bolt. Blade should be square to vise.
8. Repeat Steps 6–7 as necessary, then tighten
jam nut against stop block (see Figure 93)
without turning stop bolt.
Model G0812 (Mfd. Since 2/16)
Blade
Stop Bolt
Setting 45° Right Angle Stop
1.
Raise headstock to highest position.
2.
DISCONNECT MACHINE FROM POWER!
3.
Rotate flip-stop
Figure 93).
4.
Rotate swivel lock handle toward base, then
rotate headstock counterclockwise until base
contacts 45° stop bolt (see Figure 94).
45° Right Stop Bolt
Jam Nut
Figure 94. 45° right stop bolt and jam nut
location.
5. Slide vise to left position and secure it. Refer
to Changing Vise Position on Page 34.
6. Connect machine to power and lower head-
stock all the way until it stops moving.
7. DISCONNECT MACHINE FROM POWER
and place 45° square between vise jaw and
blade, as shown in Figure 95. The square
should fit snugly against outer fixed jaw and
blade.
Blade
Figure 95. Using 60° square to check 45° stop.
out completely (see
Swivel Lock
Handle
Outer
Fixed Jaw
45° Square
-59-