Blade Brush; Downfeed Stop Bolt - Grizzly G0812 Owner's Manual

Blade Brush

The Model G0812 has a blade brush to help keep
metal chips off the blade wheels. It will wear over
time and require re-adjustment when it no longer
makes proper contact with the blade. Eventually
the brush will require replacement. This is con-
sidered a normal wear item and is not covered by
warranty.
Tool Needed
Open-End Wrench 14mm .................................. 1
To adjust blade brush:
1.
DISCONNECT MACHINE FROM POWER!
2. Using hex nut shown in Figure 80, adjust
blade brush so blade extends
of brush.
Figure 80. Adjusting brush adjustment hex nut.
-54-
The Model G0812 has an adjustable stop bolt to
help support the headstock at the bottom of its
travel. If the blade does not travel far enough to
complete the cut or hits the table, this bolt will
have to be adjusted.
Tool Needed
Open-End Wrench 19mm .................................. 1
Qty
To adjust downfeed stop bolt:
1.
⁄ " into bristles
1
8
2.
3.
Blade Brush
4.

Downfeed Stop Bolt

Without starting blade, lower headstock all the
way. When headstock stops, blade should be
just below table, but not contacting it.
— If blade contacts table, raise headstock
enough so blade is just below surface.
DISCONNECT MACHINE FROM POWER!
Adjust downfeed stop bolt and jam nut shown
in Figure 81, so they contact bottom of head-
stock.
Jam Nut
Figure 81. Downfeed stop bolt and jam nut
location.
Tighten jam nut against base to prevent stop
bolt from loosening during use.
Model G0812 (Mfd. Since 2/16)
Qty
Stop Bolt