Grizzly G0812 Owner's Manual page 46

Gearbox
Lube Type ............................. ISO 320 Equivalent
Amount ................................................... 0.84 Qt.
Lubrication Frequency .........50 Hrs. of Operation
The gearbox should be drained and refilled after
the first 50 hours of use, and then once every five
months.
To change gearbox oil:
1. Run machine for 10 minutes to warm up oil in
gearbox.
2. Raise headstock to highest position.
3. DISCONNECT MACHINE FROM POWER!
4. Remove fill plug shown in Figure 67.
Figure 67. Gearbox fill plug and sight glass.
5.
Place drain pan under drain plug, then remove
drain plug (see Figure 68) and drain oil.
Drain Plug
Figure 68. Location of drain plug.
-44-
Fill Plug
Sight Glass
6. Replace drain plug, remove drain pan, then
lower headstock to its lowest position.
7. Fill gearbox with oil until oil level is at halfway
point in sight glass, then replace fill plug.
Headstock Pivot-Point
Lube Type ............. T26419 or NLGI#2 Equivalent
Amount ............................................. 1–2 Pumps.
Lubrication Frequency ...........8 Hrs. of Operation
Grease Gun ....................................................... 1
Add grease to headstock pivot-point grease fit-
tings shown in Figure 69.
Grease Fittings
Figure 69. Pivot-point grease fitting locations.
Model G0812 (Mfd. Since 2/16)