Grizzly G0812 Owner's Manual page 35

6. Loosen cap screw shown in Figure 37 on
Page 32, and align front of work stop arm
with "0" mark on stop rod scale, as shown in
Figure 39.
7. Adjust hex bolt on work stop to just touch
blade, then tighten jam nut against work stop
(see Figure 39).
Note: The work stop rod will need to be re-
calibrated any time it is removed or reposi-
tioned on the opposite side of the machine.
Blade
0 Mark
Work
Stop
Scale
Figure 39. Top view of work stop rod aligned
with "0" on scale and hex bolt touching blade.
Using Work Stop
1. Loosen cap screw shown in Figure 40, and
adjust work stop arm relative to depth of cut
indicated on stop rod scale.
2. Loosen work stop knob (see Figure 40), and
adjust horizontal position of hex bolt relative
to end of workpiece, then tighten cap screw
and knob.
Work Stop
Arm
Cap
Screw
Figure 40. Work stop set for repetitive cutting
operation.
Model G0812 (Mfd. Since 2/16)
Hex Bolt
Jam Nut
Work Stop Arm
Hex Bolt
Knob
Scale
Repositioning Work Stop
1.
To use work stop on opposite side of machine
for straight or angle cuts (see Figure 41),
remove work stop arm from stop rod, then
remove stop rod.
Work Stop
Figure 41. Work stop repositioned.
2. Reposition vise as necessary for operation
(refer to Vise on Page 36).
3. Follow Steps 1–4 in Setting Work Stop on
Page 32 to properly re-install stop rod.
4. Re-install work stop onto work stop arm so
hex bolt and jam nut face blade, re-install
work stop arm onto stop rod, then follow
Steps 5–6 in Setting Work Stop.
Prior Position
-33-