Grizzly G0812 Owner's Manual page 62

— If square fits snugly against outer fixed jaw
and blade, no further steps are necessary.
— If square does not fit snugly against outer
fixed jaw and blade, loosen jam nut shown
in Figure 94 on Page 59. Thread stop
bolt inward or outward as necessary, until
square fits snugly against fixed jaw base
while base contacts stop bolt.
8.
Tighten jam nut without turning stop bolt.
Setting 60° Left Angle Stop
1. Repeat Steps 1–3 from Setting 45° Right
Angle Stop on Page 59.
2.
Rotate swivel lock handle toward base, then
rotate headstock clockwise until base con-
tacts 60° left stop bolt (see Figure 96).
60° Left Stop Bolt
Figure 96. 60° left stop bolt and jam nut location.
3. Slide vise to right position and secure it. Refer
to Changing Vise Position on Page 34.
4. Connect machine to power and lower head-
stock all the way until it stops moving.
-60-
5. DISCONNECT MACHINE FROM POWER
and place 60° square between outer fixed
jaw and blade, as shown in Figure 97. The
square should fit snugly against outer fixed
jaw and blade.
60°
Square
Figure 97. Using 60° square to check 60° left
— If square fits snugly against outer fixed jaw
— If square does not fit snugly against outer
Jam Nut
6. Tighten jam nut without turning stop bolt, then
tighten swivel lock handle to secure head-
stock.
Outer Fixed Jaw
Blade
angle stop.
and blade, no further steps are necessary.
fixed jaw and blade, loosen jam nut shown
in Figure 96. Thread stop bolt inward or
outward as necessary until square fits
snugly against outer fixed jaw and blade
while base contacts stop bolt.
Model G0812 (Mfd. Since 2/16)