8.14. High Voltage Board and Reg. Thermistor Sensor
Before performing the following steps, remove all covers, power supply unit, main control shield cover assembly and engine board
shield cover.
(1)
Remove the 2 screws (A) and 3 screws (B).
(2)
Separate the PC earth spring and high voltage unit
(consists of high voltage board, high voltage board shield
cover, etc.) from the chassis.
(3)
Disconnect the 4 connectors.
(4)
Separate the high voltage board from the high voltage
board shield cover (4 screws (C)).
147
DP-CL18