DP-CL18
8.11. Paper Feed Unit
Before performing the following steps, remove the rear cover, left cover and front door.
(1)
Remove the clip.
(2)
Slide out the registration clutch and registration roller joint
gear.
Note:
When reinstalling the registration clutch, opening (A) of
registration clutch must be aligned with hook (B).
(3)
If necessary, disconnect the connector CN20 on the engine
board
(see
section
Temperature/Humidity Sensor Boards").
(4)
Remove the 2 screws.
(5)
Disconnect the connectors CN18 and CN19 on the engine
board
(see
section
Temperature/Humidity Sensor Boards").
(6)
Remove the paper feed unit while pulling out the cable
through the opening of chassis.
8.7.1
"Engine
Control
8.7.1
"Engine
Control
and
and
140