DP-CL18
8 Removal and Replacement Procedures
Before performing the following steps, unplug the AC
power cord, then remove the 4 toner cartridges (cyan,
magenta, yellow and black), 2 print cartridges (black and color),
waste toner cartridge and standard paper cassette from the
printer.
Caution: Don't loosen or remove any component (nuts,
screws, fasten terminals, etc.) on (from) the IH coil unit.
A large current (approx. 12Arms: 100V AC Power) flows
8.1.
Fuser Unit
Caution:
1. The fuser is hot. To avoid personal injury, wait 1 hour for fuser to cool after turning the power off, and then service it.
2. When replacing parts, use only the manufacturer's specified components.
3. After servicing, be sure to restore the lead dress, insulation barriers, insulation papers, shields, etc.
(1)
Open the front door.
(2)
Disconnect the fuser connector from the printer.
(3)
Move the 2 fuser lock green tabs in the arrow directions to
unlatch the fuser unit.
(4)
Remove the fuser unit.
in the IH coil, IH cable, thermostat cables and
thermostats. The nuts, screws and fasten terminals
connect the IH cable to the IH coil and thermostats. For
protection from fire, smoke and other hazard, don't
loosen or remove any component on (from) the IH coil
unit.
116