8.8.
LSU (Laser Scanning Unit)
Before performing the following steps, remove the left, top and rear covers (see section 8.5 "Rear, Left and Top Covers").
(1)
Remove the LSU earth plate (4 screws).
(2)
Remove the 3 LSU screws from the LSU.
(3)
Separate the LSU from the printer.
(4)
Disconnect the 3 connectors from the LSU.
8.9.
Paper Exit
Before performing the following steps, remove the parts that are listed below:
1. all covers (see sections 8.3, 8.4 and 8.5)
2. Paper Pickup Motor Bracket (see section 8.7.4 "Paper Pickup Motor and Motor Bracket")
(1)
Remove the 2 screws.
(2)
Disconnect the 2 connectors.
(3)
Remove the inner cover.
(4)
If necessary, remove the ADU (Automatic Duplex Unit)
detection sensor and ADU jam detection sensor board from
the inner cover.
133
DP-CL18