DP-CL18
11 Adjustment
11.1. Print Position Calibration
This adjustment is used to set the print position calibration after moving the printer, installing the optional paper feeder, replacing
the engine control board or replacing the laser scanning unit (LSU).
1. Turn on the printer and enter the User Mode (or Service Mode).
2. If the User Mode is activated, select "Tray" item menu in the User Mode and press the Enter or Continue button.
3. Select "Position Setting" in the "Tray" item menu (or select "Position Setting" item menu in the Service Mode) and press the
Enter or Continue button.
4. Select the Test Print and press the Enter or Continue button.
5. Select the menu which the Print Position Calibration is needed, and press the Enter button. The Test Print is done (see figure-
1).
6. Verify that A and B match the values in the following table.
7. If necessary, adjust the Print Position Calibration using "Position Setting" menu in User Mode (or using "Position Setting" item
menu in the Service Mode).
198