Fuser Fan Motor; Detection Switches - Panasonic DP-CL18 Service Manual

8.17. Fuser Fan Motor

Before performing the following steps, remove rear, left and top covers.
(1) Open the right cover.
(2) Remove the screw and fuser fan motor from the chassis.
(3) Remove the insulation sheet and then disconnect the fan
cable from the fan motor.
(4) Disconnect the connector CN44 on the engine control
board (see section
Temperature/Humidity Sensor Boards") and remove the
fuser fan cable from the chassis.
8.18. Front Door Open Detection and Right Cover Open Detection Switches
Before performing the following steps, remove the rear cover, right cover, top cover and front door.
(1) Remove the 3 interlock cover screws and interlock cover.
(2) Disconnect the cable (A), and remove the front door open
detection sensor.
(3) If necessary, the cable (A) connector CN7 on the engine
control board (see section 8.7.1 "Engine Control and
Temperature/Humidity Sensor Boards").
(4) Disconnect the cable (B) from the power supply unit [see
section 8.12 "Power Supply Unit (Power Supply Board and
IH Power Board)].
(5) Disconnect the cable (C) connector CN35 on the engine
control board (see section 8.7.1 "Engine Control and
Temperature/Humidity Sensor Boards").
(6) Remove the 2 screws and safety interlock switches from the
interlock switch bracket.
(7) Remove the screw and interlock switch bracket.
8.7.1 "Engine Control and
153
DP-CL18