Ethernet Management Port; Dce/Dte Switch; Serial Ports; Reset Button - Nortel 8600 Series Installing

Ethernet routing switch
Hide thumbs Also See for 8600 Series:
Table of Contents

Advertisement

Label
Master
Online

Ethernet management port

The Ethernet management port on the 8692SF module is an Medium
Dependent Interface (MDI) 10/100BASE-T port that allows out-of-band
management of the switch using a Web browser or Device Manager. You
can also establish a TELNET or SSH (Secure Shell) session to access the
CLI. Use this port to connect the switch to a network management station.
The Ethernet management port has its own IP address but does not switch
traffic to other ports in the chassis.
This port can be used only as a management port. This port provides
out-of-band management for the 8692SF module.

DCE/DTE switch

The DCE/DTE switch changes the pin assignments on the Console port
and allows you to designate the connector as either DTE or DCE. For
information about pin assignments for the Console port, see
port" (page

Serial ports

The 8692SF module provides two serial ports for attaching modem and
console devices. The Console port provides terminal access to the 8692SF
module to use the CLI. The Modem port allows you to connect a standard
modem for out-of-band, dial-up management. For information about pin
assignments for these ports, see

Reset button

The recessed Reset button on the module allows you to perform a hard
reset or reboot of the system. To press the Reset button, insert a small
object (for example, a paper clip) into the Reset button hole.
Copyright © 2007, Nortel Networks
.
Color/State
Green/Steady
Green/Blinking
Amber/Steady
Off
Green/Steady
Amber/Steady
Off
137).
Nortel Ethernet Routing Switch 8600
Installing Ethernet Routing Switch 8600 Modules
NN46205-304 01.03 Standard
4.1 2 January 2007
Meaning
The CPU subsystem on the module is
performing diagnostics.
This module is providing active CPU functions
for the switch and is the master CPU module.
The CPU subsystem is in a fault state.
The CPU subsystem on the module is up and is
in standby mode.
The switch fabric portion of the module is online
and is load-sharing.
The switch fabric portion of the module has
failed diagnostics.
The switch fabric portion of the module is
off-line.
"Modem serial port" (page
8692SF module 71
"Console serial
137).
Nortel Networks Confidential

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents