8672Atme And 8672Atmm Modules - Nortel 8600 Series Installing

The 8648TXE module does not support R or M mode. The 8648TXM
module supports R and M mode. For specific R and M mode configuration
requirements, see
mode configuration requirements" (page

8672ATME and 8672ATMM modules

Both the 8672ATME and 8672ATMM modules
"8672ATME/8672ATMM module with an OC-12c/STM-4 MDA" (page
have two bays for installing ATM MDAs. These MDAs provide interface
flexibility and ATM network transmission that supports RFC 1483 routed
and bridged permanent virtual connections (PVC). The 8672ATME and
8672ATMM modules support Synchronous Optical Network (SONET) and
Synchronous Digital Hierarchy (SDH) frame structures for data.
Figure 22
8672ATME/8672ATMM module with an OC-12c/STM-4 MDA
The module requires at least one of the following MDAs:
•
•
•
For more information about the MDAs for the 8672ATME and 8672ATMM
module, see Installing Media Dependent Adapters for the 8672ATME and
8672ATMM Modules.
In the data center, the 8672ATME and 8672ATMM modules act as an edge
device for WAN connectivity to connect an Ethernet Routing Switch 8600 to
public or private ATM networks. In the wiring closet, this module provides
inter-building connections for campus networks where each building is
supported by frame-switched networks.
You can install up to six 8672ATME or 8672ATMM modules in one 8010
10-slot chassis. You can install up to four 8672ATME or 8672ATMM
modules in one 8006 6-slot chassis. You can install up to two 8672ATME
or 8672ATMM modules in a 8003 3-slot chassis.
Copyright © 2007, Nortel Networks
.
"M mode configuration requirements" (page 24)
1-port OC-12c/STM-4: single mode fiber (SMF) or multimode fiber
(MMF) using the SONET or SDH media
4-port OC-3c/STM-1: SMF or MMF using SONET or SDH media
2-port DS-3
Nortel Ethernet Routing Switch 8600
Installing Ethernet Routing Switch 8600 Modules
NN46205-304 01.03 Standard
4.1 2 January 2007
8672ATME and 8672ATMM modules 49
25).
(Figure 22
Nortel Networks Confidential
and "R
49))