Power Safety Precautions; Power Source; Disconnecting Power - Xerox Phaser 6600 Service Manual

Power Safety Precautions

Power Source

For 115 VAC printers, do not apply more than 127 volts RMS between the supply conductors or
between either supply conductor and ground. For 230 VAC printers, do not apply more than 254 volts
RMS between the supply conductors or between either supply conductor and ground. Use only the
specified power cord and connector. This manual assumes that the reader is a qualified service
technician.
Plug the three-wire power cord (with grounding prong) into a grounded AC outlet only. If necessary,
contact a licensed electrician to install a properly grounded outlet. If the product loses its ground
connection, contact with conductive parts may cause an electrical shock. A protective ground
connection by way of the grounding conductor in the power cord is essential for safe operation.

Disconnecting Power

WARNING: Turning the power Off using the power switch does not completely de-energize the
printer. You must also disconnect the Power Cord from the printer's Alternating Current (AC) inlet.
Disconnect the Power Cord by pulling the plug, not the cord.
Disconnect the Power Cord in the following cases:
• if the power cord or plug is frayed or otherwise damaged,
• if any liquid or foreign material is spilled into the product,
• if the printer is exposed to any excess moisture,
• if the printer is dropped or damaged,
• if you suspect that the product needs servicing or repair,
• whenever you clean the product.
Xerox Internal Use Only
General Information
Phaser 6600 and WorkCentre 6605
Service Manual
1-5