Print Function Test (Test Print) - Xerox Phaser 6600 Service Manual

Error Troubleshooting
Press the OK button.
6.
The number changed will be written in and the screen returns to the previous screen.
Press the Back button to return to the [Printer Diag] screen.
7.
8. Exit Service Mode. See "How to Exit Service Mode" on page 2-10.

Print Function Test (Test Print)

You can perform the Test Print using the prepared patterns for the print test. In the event of paper jam
or out of paper, wait until the error is released.
Note: Do not remove the cassette while the test is being executed. Before the print test, check that
the paper tray contains enough paper.
Procedure for the Print Function Test
This section explains how to print a test pattern using Pattern IOT as an example.
1. Enter Service Mode. See "How To Enter Service Mode" on page 2-8.
Confirm that [Printer Diag] is selected, and press the OK button.
2.
3. Use the [ ] button to select [Test Print], and press the OK button.
Printer Diag
Test Print
4. Use the [ ] button to select [Pattern IOT], and press the OK button.
Test Print
Pattern IOT
Press the OK button to print the test pattern.
5.
The screen will return to the [Ready] screen after printing.
Pattern IOT
Processing
Press the Back button to return to the [Printer Diag] screen.
6.
7. Exit Service Mode. See "How to Exit Service Mode" on page 2-10.
2-40 Phaser 6600 and WorkCentre 6605
Service Manual
Installation
SerialNo.
Printer Diag
Installation
Printer Diag
Test Print
Test Print
No Image IOT
Pattern IOT
Ready
Pattern IOT
Ready
Xerox Internal Use Only