Dadf Assembly / Iit Assembly - Xerox Phaser 6600 Service Manual

DADF Assembly / IIT Assembly

PL51.1.2 / PL51.1.3
WARNING: The Fuser is very hot. Take added care when handling the fuser to avoid being burned.
1. Remove the Fuser Assembly. (page 4-46)
2. Remove the Waste Cartridge. (page 4-50)
3. Remove the Waste Cartridge Lock. (page 4-39)
4. Remove the Front Door Assembly. (page 4-128)
5. Remove the Right Cover Assembly. (page 4-131)
6. Remove the Left Cover Assembly. (page 4-136)
7. Remove the Lower Left Hand Rear Cover. (page 4-124)
8. Remove the Upper Right Hand Pole Cover. (page 4-122)
9. Remove the Control Panel Assembly. (page 4-8)
10. Remove the Scanner Assembly. (page 4-138)
11. Turn the Scanner Assembly over.
12. Remove the screw (silver, tapping, 8mm) that attaches the Harness Cover to the IIT Assembly and
remove the cover. Save the cover for re-use during reassembly.
13. Release the IIT Assembly harness from the groove on the underside of the IIT Assembly.
Xerox Internal Use Only
Service Parts Disassembly
Phaser 6600 and WorkCentre 6605
Service Manual
s6600-097
4-143