Lubrication
Greasing the Bearings and
Bushings
Service Interval: Every 50 hours (And after every
washing).
Grease specification: No. 2 lithium grease
The grease fitting locations and quantities are as
follows:
•
Brake-shaft pivot bearings (5) as shown in
58
Figure 58
•
Rear-axle-pivot bushings (2) as shown in
59)
Figure 59
•
Steering-cylinder ball joints (2) as shown in
60
Figure
g009704
1. Top fitting on kingpin
•
Tie-rod ball joints (2) as shown in
Figure
•
Kingpin bushings (2) as shown in
Important:
should only be lubricated annually (2 pumps).
•
Lift-arm bushings (1 per deck) as shown in
61
g009705
•
Lift-cylinder bushings (2 per deck) as shown in
Figure 61
53
Figure 60
Figure 60
Figure 60
The top fitting on the kingpin
Figure 61
Figure
g009706
Figure
g009707