Adjusting The Height Of Cut - Toro Groundsmaster 4500-D Operator's Manual

Lowering the Roll Bar
Important:
Lower the roll bar only when
necessary.
Important:
Ensure that the seat is secured with
the seat latch.
Figure 22
Raising the Roll Bar
Figure 23

Adjusting the Height of Cut

Important:
The mower decks often cut
approximately 6 mm (1/4 inch) lower than a reel
cutting unit with the same bench setting. It may
be necessary to set the mower deck's bench 6 mm
(1/4 inch) above that of reel cutting units cutting
in the same area.
Important:
Access to the rear mower decks is
greatly improved by removing the mower deck
from the machine.
1. Park the machine on a level surface, engage
the parking brake, lower the mower deck to the
ground, shut off the engine, and remove the key.
2. Loosen the bolt securing each height-of-cut
bracket to the height-of-cut plate (front and each
side) as shown in
3. Beginning with front adjustment, remove the
bolt.
g201853
1. Height-of-cut bracket
2. Height-of-cut plate
4. While supporting the chamber, remove the
spacer (Figure
g201854
5. Move the chamber to the desired height of
cut and install a spacer into the designated
height-of-cut hole and slot
6. Position the tapped plate in-line with the spacer.
29
Figure 24.
Figure 24
3. Spacer
24).
(Figure 25).
Figure 25
g011344
g201855