Checking The Torque Of The Wheel-Lug Nuts; Adjusting The Rollover Protection System (Rops) - Toro Groundsmaster 4500-D Operator's Manual

Checking the Torque of the
Wheel-Lug Nuts
Service Interval: After the first hour
After the first 10 hours
Every 200 hours
Torque the wheel-lug nuts to 115 to 136 N∙m (85 to 100
ft-lb) in the order shown in
Figure 20
Front Wheels
Figure 21
Rear Wheels
WARNING
Failing to maintain proper torque of the
wheel-lug nuts could result in personal injury.
Torque the wheel-lug nuts to the proper
torque value.
Figure 20 and Figure 21.
Adjusting the Rollover
Protection System (ROPS)
WARNING
To avoid injury or death from rollover: keep
the roll bar in the raised locked position and
use the seat belt.
Ensure that the seat is secured with the seat
latch.
WARNING
There is no rollover protection when the roll
bar is in the down position.
• Do not operate the machine on uneven
ground or on a hill side with the roll bar in
the down position.
g033358
• Lower the roll bar only when absolutely
necessary.
• Do not wear the seat belt when the roll bar
is in the down position.
• Drive slowly and carefully.
• Raise the roll bar as soon as clearance
permits.
• Check carefully for overhead clearances
(i.e., branches, doorways, electrical wires)
g033359
before driving under any objects and do
not contact them.
Important:
Always use the seat belt when the
roll bar is in the raised and locked position. Do
not use the seat belt when the roll bar is in the
lowered position.
28