Removing And Installing The Mower Blade(S) - Toro Groundsmaster 4500-D Operator's Manual

5. Rotate the marked end of the blade to the 3 and
9 o'clock positions
the heights.
6. Compare the 12 o'clock measured height to the
height-of-cut setting. It should be within 0.7 mm
(0.030 inch). The 3 and 9 o'clock heights should
be 1.6 to 6.0 mm (0.060 to 0.240 inch) higher
than the 12 o'clock setting and within 2.2 mm
(0.090 inch) of each other.
If any of these measurements are not within
specification, proceed to
(page 75).
Adjusting the Blade Plane
Start with the front adjustment (change 1 bracket at a
time).
1. Remove the height-of-cut bracket, (front, left, or
right) from the deck frame
2. Adjust 1.5 mm (0.060 inch) shims and/or 0.7 mm
(0.030 inch) shims between the deck frame and
bracket to achieve the desired height setting
(Figure 102).
Figure 102
1. Height-of-cut bracket
3. Install the height-of-cut bracket to the deck
frame with the remaining shims assembled
below the height-of-cut bracket.
4. Secure the socket-head bolt/spacer and flange
nut.
Note:
Socket-head bolt/spacer are held
together with thread-locking adhesive to prevent
the spacer from falling inside the deck frame.
5. Verify the 12 o'clock height and adjust if needed.
6. Determine if only 1 or both (right and left)
height-of-cut brackets need to be adjusted.
Note:
If the 3 or 9 o'clock side is 1.6 to 6.0 mm
(0.060 to 0.240 inch) higher than the new front
(Figure 101) and measure
Adjusting the Blade Plane
(Figure 102).
2. Shims
height then no adjustment is needed for that
side. Adjust the other side to within ± 2.2 mm
(0.090 inch) of the correct side.
7. Adjust the right and/or left height-of-cut brackets
by repeating steps
8. Secure the carriage bolts and flange nuts.
9. Verify the 12, 3, and 9 o'clock heights.
Removing and Installing
the Mower Blade(s)
Replace the blade if it hits a solid object, is out of
balance, or if it is bent. Always use genuine Toro
replacement blades to ensure safety and optimum
performance.
1. Park the machine on a level surface, raise the
mower deck to the highest position, engage the
parking brake, shut off the engine, and remove
the key.
Note:
Block the mower deck to prevent it from
accidentally falling.
2. Grasp the end of the blade using a rag or
thickly-padded glove.
3. Remove the blade bolt, anti-scalp cup, and
blade from the spindle shaft
g011354
1. Blade bolt
4. Install the blade, anti-scalp cup, and blade bolt
and tighten the blade bolt to 115 to 149 N∙m (85
to 110 ft-lb).
Important:
must be pointing toward the inside of the
mower deck to ensure proper cutting.
Note:
After striking a foreign object, torque all
of the spindle-pulley nuts to 115 to 149 N∙m (85
to 110 ft-lb).
75
1 through 4.
(Figure
Figure 103
2. Anti-scalp cup
The curved part of the blade
103).
2
1
G011355
g011355