3
2
1
Figure 6
1. Bolt
2. Nut
G012631
g012631
3. Arm of hood-latch bracket
3
Adjusting the Roller
Scraper (Optional)
No Parts Required
Procedure
The optional rear roller scraper is designed to work
best when there is an even gap of 0.5 to 1 mm (0.020
to 0.040 inch) between the scraper and roller.
1. Loosen the grease fitting and the mounting
screw
(Figure
1. Roller scraper
2. Mounting screw
2. Slide the scraper up or down until a gap of 0.5 to
1 mm (0.020 to 0.040 inch) is achieved between
the rod and the roller.
3. Secure the grease fitting and screw to 41 N∙m
(30 ft-lb) in an alternating sequence.
13
7).
1
3
Figure 7
3. Grease fitting
2
G011346
g011346