Adjusting The Height Of Cut; Using The Transport Lock - Toro Titan ZXM4875 Operator's Manual

Adjusting the Height of Cut

You can adjust the height of cut from 38 to 127 mm (1-1/2 to 5 inches) in 6.4 mm (1/4 inch)
increments.
1. Push the deck-lift pedal
raise the mower deck.
2. Remove the pin
bracket.
3. Insert the pin into the hole corresponding to
the desired height of cut
4. Lower the deck slowly until the lever contacts
the pin.

Using the Transport Lock

1. Push the deck-lift pedal
the mower deck in the T
2. Push the deck-lift pedal fully forward and push
the transport lock lever
U
NLOCK
deck to the desired height of cut.
3464-637B
with your foot to
from the height-of-cut
.
fully forward to lock
RANSPORT
forward to the
position, then slowly lower the mower
G455680
position.
G456097
Page 4–22 Operation: During Operation