Remove The Top Cover From The Node; Transfer Parts From The Faulted Node To The Replacement Node - Dell EMC PowerStore T Installation And Service Manual

Remove the top cover from the node

Steps
1. While pushing down the two blue release buttons, slide the top cover towards the rear of the system, until it stops.
Figure 107. Releasing the top cover
2. Lift the top cover upward, and remove it from the node.
Figure 108. Removing the top cover
Transfer parts from the faulted node to the replacement
node
Transfer the following components from the faulted node to the corresponding locations in the replacement node.
To help ensure the correct placement in the enclosure, transfer only one component at a time.
• Transfer the power supply.
• Transfer the I/O modules
• Transfer the embedded module
• Transfer the internal M.2 boot modules
• Transfer DIMMs.
• Transfer internal fans.
• Transfer the internal battery backup
and fillers.
without removing the 4-port card.
without removing them from the adapters.
module.
Base enclosure service procedures 77