Install A 2.5" Drive - Dell EMC PowerStore T Installation And Service Manual

Figure 20. Pushing the latch cover up
3. Push down the orange button to release the latch.
4. Remove the drive from the slot.
Figure 21. Removing a 2.5" drive
5. Place the drive on a static-free surface.

Install a 2.5" drive

About this task
NOTE: If you are installing multiple drives in a system that is powered up, wait at least 10 seconds before sliding the
next drive into position.
Steps
1. Align the drive with the guides in the slot.
2. With the latch fully opened, gently push the drive into the slot.
The latch begins to rotate downward when it meets the enclosure.
3. Push the orange button until the drive is fully seated in the slot.
4. Push the latch down until it locks into place.
28 Base enclosure service procedures