Embedded Module Leds; Power Down The Node; Remove A Faulted Embedded Module - Dell EMC PowerStore T Installation And Service Manual

Faulted parts appear in red in the image of the system, and report a status of Faulted in the State field.

Embedded module LEDs

Use the fault LEDs to identify the faulted part.
Figure 30. Embedded module LEDs
Table 2. Embedded module LEDs
LED
Embedded module fault
Ethernet port link
Ethernet port activity
SAS port and activity link
Port link
Node fault
Node power
Unsafe to remove

Power down the node

Power down the node as described in

Remove a faulted embedded module

Steps
1. Label and disconnect all cables that are attached to the embedded module.
Location
Power control procedures.
State Description
Amber Embedded module has faulted.
Off No fault has occurred, normal operation.
Green Link established.
Off No link established.
Amber blinking Port activity.
Off No port activity.
Blue SAS port link is up.
Off No link established.
Green Link up with high speed.
Amber Link up with degraded speed.
Off Link down.
Amber Fault has occurred in the node or one of its
components.
Off No fault has occurred. Normal operation.
Green Node is on (main power).
Off Node is off.
White Do not remove the node. Improper removal
could cause data loss.
Off Safe to remove the node when the node
has been properly prepared.
Base enclosure service procedures 35