Replace A 4-Port Card; Identify A Faulted Part From Powerstore Manager; Embedded Module Leds - Dell EMC PowerStore T Installation And Service Manual

Replace a 4-port card

Take the following actions to remove the 4-port card and install the replacement 4-port card into the system.

Identify a faulted part from PowerStore Manager

Before you replace a part, ensure that you have identified its location within the system. Using PowerStore Manager, you can identify and
locate a faulted part.
Steps
1. From PowerStore Manager, select Hardware.
2. Select the appliance that contains the faulted part.
3. From the Hardware card, select the view of the system where the faulted part is located.
Faulted parts appear in red in the image of the system, and report a status of Faulted in the State field.

Embedded module LEDs

Use the fault LEDs to identify the faulted part.
Figure 39. Embedded module LEDs
Table 3. Embedded module LEDs
LED
Embedded module power
Ethernet port link
Ethernet port activity
SAS port and activity link
Port link
Node fault
40 Base enclosure service procedures
Location State
Amber
Off
Green
Off
Amber blinking
Off
Blue
Off
Green
Amber
Off
Amber
Amber or blue
blinking
Blue and amber
alternating (green for
3 seconds)
Description
Embedded module has faulted.
No fault has occurred, normal operation.
Link established.
No link established.
Port activity.
No port activity.
SAS port link is up.
No link established.
Link up with high speed.
Link up with degraded speed.
Link down.
Fault has occurred.
System is booting.
System not initialized. A management IP
address has not been assigned.