Power Up The Node; Verify The Operation Of A Replacement Part - Dell EMC PowerStore T Installation And Service Manual

Figure 37. Installing the embedded module
2. When the embedded module is fully seated, push the release lever back into the system until the orange tab locks the lever in place.
Figure 38. Locking the release lever
3. Connect each cable into the same port from which it was removed.

Power up the node

Power up the node as described in

Verify the operation of a replacement part

Steps
1. From PowerStore Manager, select Hardware.
2. Select the appliance where you replaced the faulted part.
3. From the Hardware card, select the view of the system where the part was replaced.
The status of the replacement part should read Healthy. If the status is still Faulted, wait a few minutes and refresh PowerStore
Manager. If the status does not change, ensure that the part is correctly seated, or contact your service provider.
Power control procedures.
Base enclosure service procedures 39